activation problem

(Read 6554 times)

ozsuakin Member ★★ Offline Posts: 8	Jan 30^th, 2012 at 4:03pm hello, everybody, in the activation page, my control information as belows: Status OK User Terminal MAC 00A0BC2643EE Forward Link SNR 8.4 dB Return Link SNR 12.2 dB Your IP address 10.167.1.207 forward link snr is red color, any problem with this? 8.4 is enough for activation? Thanks for helps...
Back to top	IP Logged

creusetec Member ★★ Offline Posts: 27	Reply #1 - Jan 30^th, 2012 at 10:48pm If its in red its not good I would re check the dish alignment
Back to top	WWW IP Logged

bigdishsat

Member
★★
Offline

Posts: 46
France

Reply #2 - Jan 30^th, 2012 at 10:59pm

If the Forward Link signal is too low, the SNR figure will be displayed in Red and the page where you enter the activation code will not be displayed.

You either have very heavy rain or your dish is very slightly mis-pointed. Access your modem page (192.168.100.1) and go into install mode (/install), and tick your spot beam and click on the arrow.

Your Tria should give you the 'found satellite' signal which is like a mobile phone tone ... then do the fine pointing procedure again using the elevation and azimuth adjustment bolts.

Good luck.

WWW

IP Logged

ozsuakin Member ★★ Offline Posts: 8	Reply #3 - Feb 2^nd, 2012 at 1:40pm thanks for ur replies
Back to top	IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.