Advertisment:

Broadband via satellite

Advertisment:

Worldwide satellite services from Ground Control Company

Satellite Internet Forum.

Welcome, Guest. Forum rules.

Home Login Register

Satellite Internet forum › LinkStar Forum: VSAT hubs and terminals › lat and long

Pages: 1

Send Topic | Print

lat and long

(Read 5120 times)

Ex Member Ex Member	Jul 4^th, 2005 at 11:31am For the first time, I have to set up a linkstar with telnet. It's all ok, but i am not able to set latitude and longitude with SAVEBOOTPARMS -lat -lon. When i control the configuration with DBPR BOOTCONF latitude and longitude are always 0. I'm sure to insert correct value, with converting degrees minutes seconds. Could you help me?
Back to top	« Last Edit: Feb 15^th, 2007 at 9:19am by Admin1 » IP Logged

Ex Member Ex Member	Reply #1 - Apr 19^th, 2006 at 1:25pm you need to enable the gps make this command save -m 1 then enter your lat and long
Back to top	IP Logged

Eric Johnston Senior Member ★★★ Offline Posts: 2109	Reply #2 - Jan 16^th, 2007 at 3:25pm If you need to know your latitude and longitude please try this page Lat - Long Finder. It will also tell you the azimuth, elevation and polarisation angles for your satellite dish at the same time. �Select the satellite, then click progresssively on the map and magnify until you arrive at your site. Best regards, Eric.
Back to top	« Last Edit: Feb 15^th, 2007 at 9:19am by Admin1 » IP Logged

Pages: 1

Send Topic | Print

Email me: eric@satsig.net

Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-. All Rights Reserved.

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.