Pointing to EutelSat W4 for DSTV Channel

Have a look here https://www.lyngsat.com/36east.html to see all the carriers on Eutelsat W4 /SESAT at 36 deg east.  Note that only some carriers are on beams pointed to Africa. Check the beam patterns for your site and dish size.

To tune to any of these carriers, subtract either 9750 or 10600 MHz from the satellite downlink frequency.  The result is the frequency in the cable to your analyser.  Select the Universal LNB local oscillator frequency using a 22kHz tone.  22kHz tone ON = High frequency 10600 MHz selected.

If you are using a Universal LNB intended for dual polarisation satellite TV reception you will also have to use low 13 volts, or high 19 volts to switch the polarisation.  

If you are setting up a two-way transmit/receive  VSAT you then need to remove the Universal TV LNB and replace it with the VSAT feed/OMT/BUC/filter/LNB assembly.   For VSAT, I would myself use the final equipment configuration for finding the satellite.   The modem will lock up quite happily as you sweep across and find the satellite.

If you want instead, to receive from PAS7 or 10 then repeat the above procedure..

I know nothing about DSTV.

Best regards, Eric

Hi Eric,

I've tried several frequencies..I failed..Is there anyone from West Africa who've installed the Multichoice DSTV Decoder...? I can't seem to pick up anything from West Africa Guinea....

This is the W4 Nigeria steerable spot beam:

Guinea is just beyond the western edge.  If you are on the coast your level will be rather low.

This is the W4 central Africa beam:

You are in the above beam. The 12476H 26040 2/3 carrier is in this beam and is worth searching for.

There is a South Africa beam from Sesat 1; this does not cover Guinea.

See link below for complete list of programs.
https://www.lyngsat.com/packages/mcafrica36.html 
I suggest you save the page on your PC.

Dish pointing:
Use page https://www.satsig.net/maps/satellite-dish-pointing-west-africa.htm and select 36 EAST.

Polarisation:
Assuming you have a universal type LNB with switchable polarisations and switchable Ku frequency bands.   Start with the LNB upright, then while facing towards the satellite turn it about 77 deg anticlockwise.

Tuning:
Start with the satellite frequency and subtract the LNB local oscillator frequency.  Investigate the specification of your LNB to find it actual LO options, probably controllable using 13 or 19 volts, and its polarisations, probably controllable by a 22 kHz tone.

Best regards, Eric.