net modem II+

(Read 3250 times)

Ex Member Ex Member	Feb 9^th, 2008 at 12:16pm i have problem with net modem II+ i can ping +use i site + use telnet+console i can do every thing when i make line up with NOC they said transmission is very low by they way when fix i direct 3000 on the same dish+cable+lnb+buc it is work somth help me what i can do in the case
Back to top	IP Logged

Ex Member Ex Member	Reply #1 - Feb 9^th, 2008 at 12:38pm How did they diagnose the transmission as being low? Did they bring you up CW carrier and look at you? Have you put a specan on the IF port of the modem to ensure it is radiating L-Band (any freq)? I would start there and work your way thru the uplink chain.
Back to top	IP Logged

Robert12 Senior Member ★★★ Offline Posts: 61	Reply #2 - Feb 15^th, 2008 at 8:15pm the problem in the NM+ll itself , if you do small test , on same dish + cables + lnb + buc , type the command[ rx snr] in the telnet if you got it for example 10 db in the infinti modem you will got it 9 in NM+ll , same for up C/N , i think this is releated to the NM+ll itself , Regards Ahmed
Back to top	IP Logged

Lukio

Member
★★
Offline

Posts: 29

Reply #3 - Feb 16^th, 2008 at 5:10pm

Hi Chaady,

What is the serial number of the II+?

I've had TX problems with practically all II+ NM's on the networks I manage. Initially they start going low U/S SNR so you increase the TX power....which usually has no effect and eventually it goes so poor it drops out of the network altogether.

The affected batch, which is a known technical issue with iDirect, is between serial numbers 10000 and 20000 with the worst affected being serial numbers 14000 - 16000.

It may be the cause of your issues but like Mike says, thoroughly investigate your uplink chain first. If your NMII+ does have this issue it's back to iDirect/your supplier for repair I'm afraid.

Hope this helps,

Lukio ;.)

IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.