3100 problem

(Read 1894 times)

acil Member ★★ Offline Posts: 8	Mar 6^th, 2009 at 9:19am Buc power led is red. what can ı do?
Back to top	YIM \| AIM IP Logged

dot Senior Member ★★★ Offline Posts: 118	Reply #1 - Mar 6^th, 2009 at 9:58am Check your transmit cable, connectors, waterproofing, etc. Disconnect the transmit cable and power cycle the remote, if the LED remains red the remote is dead, RMA or buyy a new one. If not there is a short over over current somewhere towards the BUC.
Back to top	IP Logged

Ex Member

Ex Member

Reply #2 - Mar 6^th, 2009 at 12:08pm

Red Tx is not healthy.

I would try the above, and if you have ethernet or console access to that box I would also try to re-image that unit.

Naturally, if it is a 3100 and you are using iDS 7.1.1 or better (7.1.X, 8.X, etc) dont forget to install the upgrade_prep pkg before you engage the BSP and image.

That may resolve it, but RED is normally indicative of a hardware failure of sorts.

M

IP Logged

Pages: 1

Send Topic | Print

Disclaimer, Terms of Use and Privacy Forum User Agreement Forum rules Cookie policy.