Advertisment: Broadband via satellite
Advertisment: Planet Earth rotating animation

www.satsig.net

Satellite Internet Forum.

Welcome, Guest.        Forum rules.
      Home            Login            Register          
Pages: 1

burst switch problem on ULC-T line card

(Read 522 times)
Alec
Member
★★
Offline



Posts: 2
Jul 7th, 2020 at 4:07pm  
Hi everyone, we just bought an iDirect IDx 4.1.2 HUB and ULC-T and ULC-R line cards. I face a problem in bringing up carrier on ULC-T line card. when I type "tx enable" command on telnet prompt, a message "Please issue tx bs to enable burst switch" appears and we can not enable TX. Pls help solve this problem!
Back to top
 
 
IP Logged
 
Admin1
YaBB Admin
★★★★★
Offline



Posts: 1137
Reply #1 - Jul 9th, 2020 at 8:53am  
I don't understand "burst switch".  The spec for the iDirect ULC-T line card suggests that it only transmits one continuous carrier type DVB-S2 or DVB-S2X.
ref: ProductSheet-ULC-T.pdf

If you have the manual look for an explanation of tx bs command.

While testing and experimenting take care not to have the output radiating to a satellite!

Back to top
 
WWW  
IP Logged
 
Pages: 1